当前位置：
首页 资源下载
搜索资源 - root raised cosine filter
搜索资源列表
-
2下载：
（Root Raised Cosine Filter）根升余弦滤波器的MATLAB代码,Root Raised Cosine Filter MATLAB code
-
-
0下载：
this is a verilog code for root raised cosine filter
-
-
0下载：
平方根升余弦滚降数字滤波器的设计 很不错的文章-Square root raised cosine roll-off digital filter design
-
-
0下载：
ADI中平方根升余弦滤波器的DSP实现
2中方法-ADI in the square root raised cosine filter of the DSP method to achieve 2
-
-
0下载：
This the PAPR simulator for SC-FDMA by using the Raised-cosine filter or Root raised-cosine filter under different rolloffFactor. -This is the PAPR simulator for SC-FDMA by using the Raised-cosine filter or Root raised-cosine filter under different r
-
-
0下载：
直接序列扩频+成型滤波，将编码后数据进行256倍扩频，再按照4倍内插根升余弦成型滤波，最后成形滤波后按4路并行输出，以满足并行输入DA的要求。-Direct Sequence Spread Spectrum+ shaping filter, the encoded data 256 times more spread spectrum, and then interpolated according to four times the root raised cosine shaping fil
-
-
0下载：
仿真滚降系数为0.22的平方根升余弦滤波器.m-Simulation of roll-off factor of 0.22 square root raised cosine filter. M
-
-
0下载：
基于FPGA实现根升余弦滤波器的研究（在MATLAB环境中）-FPGA-based implementation of the root raised cosine filter (in the MATLAB environment)
-
-
1下载：
在matlab环境下实现通信系统中的BPSK，QPSK，16QAM，调制。成型滤波和匹配滤波都采用根升余弦函数。-In the matlab environment to achieve communication system BPSK, QPSK, 16QAM, modulation. Shaping filter and matched filter are used root raised cosine function.
-
-
0下载：
Root raised cosine filter implementation in matlab, with graphs of impulse and frequency response.
-
-
0下载：
根升余弦基带成形滤波器的设计及其DSP实现.最后利用系数对称特性，在某软件无线电电台系统的DSP 芯片中编程，
实现均方根升余弦滤波器的成形滤波算法-First this essay introduces baseband shaped filter theory and
requirements of an SDR system on shaped filtering. And, the author
introduces various realization methods
-
-
0下载：
一组取值为+/-1的随机序列，每两个数据之间插入3个0，然后将序列通过一个设计好的根升余弦滤波器，并用周期图法和Welch法分别绘制信号的功率谱。再次通过根升余弦滤波器后用stem函数绘图。-A set of values is+ /-1 random sequence inserted between every two data 3 0, then the sequence through a root raised cosine filter designed,
-
-
1下载：
编写一个含QAM传输的发送和接收模块
1)分别采用复基带仿真和实带通仿真两种形式
a) 实带通仿真时, 载波频率为符号率的4倍
b)发端采用滚降系数0.5的根号升余弦滤波器
2)画出Eb/N0=15dB时的接收波形(收滤波前),取100个采样
3)画出发端输出的眼图和收端过匹配滤波后的眼图(画眼图时不加噪声)
统计误符号率和误比特率与Eb/N0的关系,画出曲线, 与理论计算的曲线相对比
-Prepare to send of one with QAM transmis
-
-
2下载：
matlab代码，根升余弦滤波器对数字基带信号进行成型滤波，匹配滤波-Matlab code, the root raised cosine filter on the digital baseband signal shaping filter, matched filter
-
-
0下载：
用matlab编写了一个，信源产生经过BPSK调制以及根号升余弦滤波器后再加上载波最后将波形图输出的程序-Using matlab prepared a source after BPSK modulation, as well as the square root raised cosine filter and then with the carrier waveform graph output of the program
-
-
0下载：
代码实现了一个根升余弦成型滤波器，2PAM信号通过此成型滤波器，并且匹配接收，画出了发送和接收波形，验证了代码的正确性。-The code designs a root raised cosine filter,2PAM signal transmitted through the filter and matched using the same filter, I plot the transmitted signal and received signal to verify the co
-
-
0下载：
Root raised cosine filter coefficients from roll off 0 to 1.Filter length is 10, oversampling is 32. Each row corresponds to one filter with specified roll off, plot it row by row
-
-
0下载：
仿真练习（第六次刘课件中有关于噪声的添加方法）
？ 编写一个含QAM传输的发送和接收模块
？ 分别采用复基带仿真和实带通仿真两种形式
？ 复基带仿真时过采样率为4倍,实带通仿真时过采样率为20倍, 实带通仿真时, 载波频率为符号率的4倍
？ 发端采用滚降系数0.5的根号升余弦滤波器
？ 画出Eb/N0=15dB时的接收波形(收滤波前),取100个采样
？ 画出发端输出的眼图和收端过匹配滤波后的眼图(画眼图时不加噪声)
？ 统计
-
-
0下载：
Design A Root-Raised Cosine Filter
-
-
0下载：
对平方根升余弦滤波器进行归一化处理，使得输出的信号更接近输入信号。-Normalized the square root raised cosine filter
-
